Sony 600TVL angled camera mount
This is a Sony Style Board Cam Mount. This goes over the standoffs or your frames supported Nylon Hex standoffs and is available in 10,15 and 20 Degree angles. To mount this, remove the lens from the capture housing, place capture housing into the back of the mount, screw lens back into housing through the mount, focus camera, tighten lock ring. There are notches in the back of the mount to keep the camera from turning. Board is clear of top and bottom plate by 1-3mm (dependent on which angle you are using.) This item was designed by pLaStIc sPiDeR and a portion of this sale will go directly to him!
Now available in 30 Degrees for the ZMR250. Note that some board cam lenses may cause the top plate to be in view at 30 degrees. If you find this is the case you will need to remove some material from the leading edge of the top plate.
Sony Style Board Cam Mount
Posted by Unknown on 10th Oct 2016
Great product just add's that finishing touch to your ZMR 250 build. The finish on this mount is really good, to be honest you really need to get up close to see that it is 3D printed. I purchased the ABS version. The colour is slightly darker than seen in the picture but only slightly. The mount works great for both the HS 1177 and the HS 1177.M 17 mm x 17 mm version. Great product thanks M.R.S. Also delivery was really quick thanks again.
Blackout Mini H Camera Mount.
Posted by Dave on 4th Dec 2015
ordered 2off camera mounts in 10 and 15deg mid afternoon on a Friday. It was delivered and fitted on my Blackout by 10am Saturday!
Doesn't get any better than that. Free postage when you spend £10 plus too.
Camera mounts work exactly as described and were fitted in minutes.
I'm new to the FPV thing so am only using the 10deg one at the moment but have the 15deg on hand.
Can't praise this company enough.
Thanks multirotor spares.